Search for question
Question

You are employed as a quality engineer and you have been asked to help in designing a limit gauge for quality control of machined shafts. Your company quality policy requires

prevention of acceptance of any defective parts. a) Using the appropriate approach allocate the tolerances for 'GO' and ʼNOT-GO' ends of a snapgauge for controlling diameter of a shaft ØAB . Support your answer with all relevant tolerance diagrams.Table 02 b) Using the diagram from part (a) showing the allocation of Limit Gauge tolerances, give an example of a situation where a shaft with a particular actual dimension is made in the tolerance, but when inspected by this Limit Gauge (worn, but still within the gauge tolerance),might be misjudged as bad. Plot it on the tolerance diagram.

Fig: 1

Fig: 2

Fig: 3

Fig: 4