Perform finite element analysis using SolidWorks Simulation on the attached file:

Anchor Bracket 2-3.SLDPRT.

Show the Von Mises stress as demonstrated in class.

Note: split lines for hole are not necessary

30*

the nowe pr

right). Assume the following.

• Material:

• Mesh:

. Fixture:

.

inum Fo

Apply a Fixed (immovable) restraint on the inclined surface.

External Load: 8600 N in the X-direction applied on the right, inside surface of

the 16 mm diameter hole between user defined Split Lines.

Determine the following:

a. Use classical equations to compute stress at the inside (concave) surface and the

outside (convex) surface of the anchor bracket at section B-B. Section B-B passes

through the center of curvature of the curved beam and is considered to be a

vertical line. Include a labeled free body diagram of the portion of the anchor

bracket to the right of section B-B (show magnitude and direction of all

reactions).

b. Include a zoomed-in image of the hole so that the force Fx = 8600 N can clearly

be seen to act between user specified Split Lines.

c. Create a stress contour plot of von Mises stress in the anchor bracket. Include

automatic labeling of maximum and minimum stress on this plot.

60

AISI 1010 Steel, hot rolled bar (use SI units)

B

In the Mesh property manager, select O Standard mesh; use the

default mesh size.

R40

I

B

20

7

R100

30

पर

20

150

016

Surface is attached to

a rigid frame (fixed).