Multisim

Search for question

Questions & Answers

Assessment Criteria The work will be assessed by comparison with an approved marking scheme. Fully correct solutions will receive the number of marks indicated. Marks will be reduced for errors in proportion to their severity. You need to indicate the units for all electrical quantities. You need to clearly present the equations used for calculations and the comparison results.


Q1: Deactivate V1 and find Rth using equivalent resistance. Compare it with the value you found practically.


Q2: Using Thevenin Equivalent Circuit, calculate IRL and compare it with the value in part 1.


For the following LOW PASS FILTER circuit: Create a 10V Peak AC waveform Run analysis between 20Hz and 20,000Hz


What is the ideal drain voltage in Fig. 11-44b? forA 2N4416 has Ipss = 10 mA and mo= 10 mA and gmo = 4000 μS. What is its gate-source cutoff voltage? What is the value of gmVGS = -1 V?


Fill in the table below. Vc (Peak Voltage in Cannel B) 6 60 600 6K 60K


1) Design equation:an op-amp circuit that solves the following differential A v_{o}^{\prime \prime \prime}+B v_{o}^{\prime \prime}+C v_{o}=D v_{i}^{\prime \prime}+E v_{i}^{\prime}+F v_{i} Where v; and v. are the input and output voltage, respectively. 2) Implement your design circuit in PSPICE or MULTISIM and plot the output voltage for a given input voltage


2.2. Draw the measured and calculated phase angles versus frequency. What is your conclusion?Interpret your observation.


1.3. Extract the output signal for each frequency and attach it to the lab report.


1.4. Draw the measured and calculated peak voltages of capacitor versus frequency. What is your conclusion? Interpret your observation.


2. Measuring the phase angle difference between the voltages of the source and capacitor


No Question Found forMultisim

we will make sure available to you as soon as possible.