6. Turning the output signal into a DC signal

Provide some method of turning your output waveform from (4) into a DC signal. If not perfectly DC, then

at least an oscillating signal, not necessarily sinusoidal, that has a ripple voltage of 99-101 mV. Assume all

the same parameters: 12 V amplitude, 60 Hz, 1 kOhm load. Hint: RC decay.

Simulate your new full circuit in LTSPICE and estimate the additional cost, assuming we want to finish the

same total number of circuits as in (5). SPICE plots and Digikey screenshots are needed here.