4. Signal processing. Now let's finish out the signal processing. Given this sensor is

on a car, you can assume: 1) you have access to 12VDC, 2) the signal needs to be a

digital signal from 0-3.3V ready for use with a CAN bus

(https://www.ti.com/lit/an/sloa101b/sloa101b.pdf?ts=1687241379481).

a. Give the circuit, with component values, you would use to transduce the

output of the potentiometer to a voltage ready for your ADC. What is the

cost of the components?

i. Answer here

b. What type of filter would you suggest adding? Why?

i. Answer here

c. What resolution would you suggest for an analog to digital converter?

Why?

i. Answer here

d. How does part c influence what topology to select for ADC?

i. Answer here

e. Explain how you are going from a change in fuel level to a digital signal

where LOW-OV, HIGH - 3.3V.

i. Answer here